blob: b640845fec67cdeab862b6fd1730e4a3f03653e1 [file] [log] [blame]
* Broadcom SATA3 PHY
Required properties:
- compatible: should be one or more of
"brcm,bcm7425-sata-phy"
"brcm,bcm7445-sata-phy"
"brcm,iproc-ns2-sata-phy"
"brcm,iproc-nsp-sata-phy"
"brcm,phy-sata3"
"brcm,iproc-sr-sata-phy"
"brcm,bcm63138-sata-phy"
- address-cells: should be 1
- size-cells: should be 0
- reg: register ranges for the PHY PCB interface
- reg-names: should be "phy" and "phy-ctrl"
The "phy-ctrl" registers are only required for
"brcm,iproc-ns2-sata-phy" and "brcm,iproc-sr-sata-phy".
Sub-nodes:
Each port's PHY should be represented as a sub-node.
Sub-nodes required properties:
- reg: the PHY number
- phy-cells: generic PHY binding; must be 0
Sub-nodes optional properties:
- brcm,enable-ssc: use spread spectrum clocking (SSC) on this port
This property is not applicable for "brcm,iproc-ns2-sata-phy",
"brcm,iproc-nsp-sata-phy" and "brcm,iproc-sr-sata-phy".
- brcm,rxaeq-mode: string that indicates the desired RX equalizer
mode, possible values are:
"off" (equivalent to not specifying the property)
"auto"
"manual" (brcm,rxaeq-value is used in that case)
- brcm,rxaeq-value: when 'rxaeq-mode' is set to "manual", provides the RX
equalizer value that should be used. Allowed range is 0..63.
Example
sata-phy@f0458100 {
compatible = "brcm,bcm7445-sata-phy", "brcm,phy-sata3";
reg = <0xf0458100 0x1e00>, <0xf045804c 0x10>;
reg-names = "phy";
#address-cells = <1>;
#size-cells = <0>;
sata-phy@0 {
reg = <0>;
#phy-cells = <0>;
};
sata-phy@1 {
reg = <1>;
#phy-cells = <0>;
};
};