| Intersil ISL1209/19 I2C RTC/Alarm chip with event in |
| |
| ISL12X9 have additional pins EVIN and #EVDET for tamper detection, while the |
| ISL1208 and ISL1218 do not. They are all use the same driver with the bindings |
| described here, with chip specific properties as noted. |
| |
| Required properties supported by the device: |
| - "compatible": Should be one of the following: |
| - "isil,isl1208" |
| - "isil,isl1209" |
| - "isil,isl1218" |
| - "isil,isl1219" |
| - "reg": I2C bus address of the device |
| |
| Optional properties: |
| - "interrupt-names": list which may contains "irq" and "evdet" |
| evdet applies to isl1209 and isl1219 only |
| - "interrupts": list of interrupts for "irq" and "evdet" |
| evdet applies to isl1209 and isl1219 only |
| - "isil,ev-evienb": Enable or disable internal pull on EVIN pin |
| Applies to isl1209 and isl1219 only |
| Possible values are 0 and 1 |
| Value 0 enables internal pull-up on evin pin, 1 disables it. |
| Default will leave the non-volatile configuration of the pullup |
| as is. |
| |
| Example isl1219 node with #IRQ pin connected to SoC gpio1 pin12 and #EVDET pin |
| connected to SoC gpio2 pin 24 and internal pull-up enabled in EVIN pin. |
| |
| isl1219: rtc@68 { |
| compatible = "isil,isl1219"; |
| reg = <0x68>; |
| interrupt-names = "irq", "evdet"; |
| interrupts-extended = <&gpio1 12 IRQ_TYPE_EDGE_FALLING>, |
| <&gpio2 24 IRQ_TYPE_EDGE_FALLING>; |
| isil,ev-evienb = <1>; |
| }; |
| |
