blob: 82e3bc0b7485a098def2f449f7fecdede66658a4 [file] [log] [blame]
* Faraday TV Encoder TVE200
Required properties:
- compatible: must be one of:
"cortina,gemini-tvc", "faraday,tve200"
- reg: base address and size of the control registers block
- interrupts: contains an interrupt specifier for the interrupt
line from the TVE200
- clock-names: should contain "PCLK" for the clock line clocking the
silicon and "TVE" for the 27MHz clock to the video driver
- clocks: contains phandle and clock specifier pairs for the entries
in the clock-names property. See
Optional properties:
- resets: contains the reset line phandle for the block
Required sub-nodes:
- port: describes LCD panel signals, following the common binding
for video transmitter interfaces; see
This port should have the properties:
reg = <0>;
It should have one endpoint connected to a remote endpoint where
the display is connected.
display-controller@6a000000 {
#address-cells = <1>;
#size-cells = <0>;
compatible = "faraday,tve200";
reg = <0x6a000000 0x1000>;
interrupts = <13 IRQ_TYPE_EDGE_RISING>;
resets = <&syscon GEMINI_RESET_TVC>;
clocks = <&syscon GEMINI_CLK_GATE_TVC>,
<&syscon GEMINI_CLK_TVC>;
clock-names = "PCLK", "TVE";
port@0 {
reg = <0>;
display_out: endpoint {
remote-endpoint = <&panel_in>;