blob: f2f64749e81817c275e2710ddffcd76efc093f59 [file] [log] [blame]
InvenSense MPU-6050 Six-Axis (Gyro + Accelerometer) MEMS MotionTracking Device
http://www.invensense.com/mems/gyro/mpu6050.html
Required properties:
- compatible : should be one of
"invensense,mpu6000"
"invensense,mpu6050"
"invensense,mpu6500"
"invensense,mpu6515"
"invensense,mpu9150"
"invensense,mpu9250"
"invensense,mpu9255"
"invensense,icm20608"
"invensense,icm20609"
"invensense,icm20689"
"invensense,icm20602"
"invensense,icm20690"
"invensense,iam20680"
- reg : the I2C address of the sensor
- interrupts: interrupt mapping for IRQ. It should be configured with flags
IRQ_TYPE_LEVEL_HIGH, IRQ_TYPE_EDGE_RISING, IRQ_TYPE_LEVEL_LOW or
IRQ_TYPE_EDGE_FALLING.
Refer to interrupt-controller/interrupts.txt for generic interrupt client node
bindings.
Optional properties:
- vdd-supply: regulator phandle for VDD supply
- vddio-supply: regulator phandle for VDDIO supply
- mount-matrix: an optional 3x3 mounting rotation matrix
- i2c-gate node. These devices also support an auxiliary i2c bus. This is
simple enough to be described using the i2c-gate binding. See
i2c/i2c-gate.txt for more details.
Example:
mpu6050@68 {
compatible = "invensense,mpu6050";
reg = <0x68>;
interrupt-parent = <&gpio1>;
interrupts = <18 IRQ_TYPE_EDGE_RISING>;
mount-matrix = "-0.984807753012208", /* x0 */
"0", /* y0 */
"-0.173648177666930", /* z0 */
"0", /* x1 */
"-1", /* y1 */
"0", /* z1 */
"-0.173648177666930", /* x2 */
"0", /* y2 */
"0.984807753012208"; /* z2 */
};
mpu9250@68 {
compatible = "invensense,mpu9250";
reg = <0x68>;
interrupt-parent = <&gpio3>;
interrupts = <21 IRQ_TYPE_LEVEL_HIGH>;
i2c-gate {
#address-cells = <1>;
#size-cells = <0>;
ax8975@c {
compatible = "ak,ak8975";
reg = <0x0c>;
};
};
};