blob: 6411c624f63acbc4f549ad7e884c4c36f9d26efe [file] [log] [blame]
#ifndef NETDEV_PCS_H
#define NETDEV_PCS_H
#include <linux/phy.h>
#include <linux/spinlock.h>
#include <linux/workqueue.h>
struct device_node;
struct ethtool_cmd;
struct fwnode_handle;
struct net_device;
enum {
MLO_PAUSE_NONE,
MLO_PAUSE_ASYM = BIT(0),
MLO_PAUSE_SYM = BIT(1),
MLO_PAUSE_RX = BIT(2),
MLO_PAUSE_TX = BIT(3),
MLO_PAUSE_TXRX_MASK = MLO_PAUSE_TX | MLO_PAUSE_RX,
MLO_PAUSE_AN = BIT(4),
MLO_AN_PHY = 0, /* Conventional PHY */
MLO_AN_FIXED, /* Fixed-link mode */
MLO_AN_INBAND, /* In-band protocol */
};
static inline bool phylink_autoneg_inband(unsigned int mode)
{
return mode == MLO_AN_INBAND;
}
/**
* struct phylink_link_state - link state structure
* @advertising: ethtool bitmask containing advertised link modes
* @lp_advertising: ethtool bitmask containing link partner advertised link
* modes
* @interface: link &typedef phy_interface_t mode
* @speed: link speed, one of the SPEED_* constants.
* @duplex: link duplex mode, one of DUPLEX_* constants.
* @pause: link pause state, described by MLO_PAUSE_* constants.
* @link: true if the link is up.
* @an_enabled: true if autonegotiation is enabled/desired.
* @an_complete: true if autonegotiation has completed.
*/
struct phylink_link_state {
__ETHTOOL_DECLARE_LINK_MODE_MASK(advertising);
__ETHTOOL_DECLARE_LINK_MODE_MASK(lp_advertising);
phy_interface_t interface;
int speed;
int duplex;
int pause;
unsigned int link:1;
unsigned int an_enabled:1;
unsigned int an_complete:1;
};
/**
* struct phylink_mac_ops - MAC operations structure.
* @validate: Validate and update the link configuration.
* @mac_link_state: Read the current link state from the hardware.
* @mac_config: configure the MAC for the selected mode and state.
* @mac_an_restart: restart 802.3z BaseX autonegotiation.
* @mac_link_down: take the link down.
* @mac_link_up: allow the link to come up.
*
* The individual methods are described more fully below.
*/
struct phylink_mac_ops {
void (*validate)(struct net_device *ndev, unsigned long *supported,
struct phylink_link_state *state);
int (*mac_link_state)(struct net_device *ndev,
struct phylink_link_state *state);
void (*mac_config)(struct net_device *ndev, unsigned int mode,
const struct phylink_link_state *state);
void (*mac_an_restart)(struct net_device *ndev);
void (*mac_link_down)(struct net_device *ndev, unsigned int mode,
phy_interface_t interface);
void (*mac_link_up)(struct net_device *ndev, unsigned int mode,
phy_interface_t interface,
struct phy_device *phy);
};
#if 0 /* For kernel-doc purposes only. */
/**
* validate - Validate and update the link configuration
* @ndev: a pointer to a &struct net_device for the MAC.
* @supported: ethtool bitmask for supported link modes.
* @state: a pointer to a &struct phylink_link_state.
*
* Clear bits in the @supported and @state->advertising masks that
* are not supportable by the MAC.
*
* Note that the PHY may be able to transform from one connection
* technology to another, so, eg, don't clear 1000BaseX just
* because the MAC is unable to BaseX mode. This is more about
* clearing unsupported speeds and duplex settings.
*
* If the @state->interface mode is %PHY_INTERFACE_MODE_1000BASEX
* or %PHY_INTERFACE_MODE_2500BASEX, select the appropriate mode
* based on @state->advertising and/or @state->speed and update
* @state->interface accordingly.
*/
void validate(struct net_device *ndev, unsigned long *supported,
struct phylink_link_state *state);
/**
* mac_link_state() - Read the current link state from the hardware
* @ndev: a pointer to a &struct net_device for the MAC.
* @state: a pointer to a &struct phylink_link_state.
*
* Read the current link state from the MAC, reporting the current
* speed in @state->speed, duplex mode in @state->duplex, pause mode
* in @state->pause using the %MLO_PAUSE_RX and %MLO_PAUSE_TX bits,
* negotiation completion state in @state->an_complete, and link
* up state in @state->link.
*/
int mac_link_state(struct net_device *ndev,
struct phylink_link_state *state);
/**
* mac_config() - configure the MAC for the selected mode and state
* @ndev: a pointer to a &struct net_device for the MAC.
* @mode: one of %MLO_AN_FIXED, %MLO_AN_PHY, %MLO_AN_INBAND.
* @state: a pointer to a &struct phylink_link_state.
*
* The action performed depends on the currently selected mode:
*
* %MLO_AN_FIXED, %MLO_AN_PHY:
* Configure the specified @state->speed, @state->duplex and
* @state->pause (%MLO_PAUSE_TX / %MLO_PAUSE_RX) mode.
*
* %MLO_AN_INBAND:
* place the link in an inband negotiation mode (such as 802.3z
* 1000base-X or Cisco SGMII mode depending on the @state->interface
* mode). In both cases, link state management (whether the link
* is up or not) is performed by the MAC, and reported via the
* mac_link_state() callback. Changes in link state must be made
* by calling phylink_mac_change().
*
* If in 802.3z mode, the link speed is fixed, dependent on the
* @state->interface. Duplex is negotiated, and pause is advertised
* according to @state->an_enabled, @state->pause and
* @state->advertising flags. Beware of MACs which only support full
* duplex at gigabit and higher speeds.
*
* If in Cisco SGMII mode, the link speed and duplex mode are passed
* in the serial bitstream 16-bit configuration word, and the MAC
* should be configured to read these bits and acknowledge the
* configuration word. Nothing is advertised by the MAC. The MAC is
* responsible for reading the configuration word and configuring
* itself accordingly.
*
* Implementations are expected to update the MAC to reflect the
* requested settings - i.o.w., if nothing has changed between two
* calls, no action is expected. If only flow control settings have
* changed, flow control should be updated *without* taking the link
* down. This "update" behaviour is critical to avoid bouncing the
* link up status.
*/
void mac_config(struct net_device *ndev, unsigned int mode,
const struct phylink_link_state *state);
/**
* mac_an_restart() - restart 802.3z BaseX autonegotiation
* @ndev: a pointer to a &struct net_device for the MAC.
*/
void mac_an_restart(struct net_device *ndev);
/**
* mac_link_down() - take the link down
* @ndev: a pointer to a &struct net_device for the MAC.
* @mode: link autonegotiation mode
* @interface: link &typedef phy_interface_t mode
*
* If @mode is not an in-band negotiation mode (as defined by
* phylink_autoneg_inband()), force the link down and disable any
* Energy Efficient Ethernet MAC configuration. Interface type
* selection must be done in mac_config().
*/
void mac_link_down(struct net_device *ndev, unsigned int mode,
phy_interface_t interface);
/**
* mac_link_up() - allow the link to come up
* @ndev: a pointer to a &struct net_device for the MAC.
* @mode: link autonegotiation mode
* @interface: link &typedef phy_interface_t mode
* @phy: any attached phy
*
* If @mode is not an in-band negotiation mode (as defined by
* phylink_autoneg_inband()), allow the link to come up. If @phy
* is non-%NULL, configure Energy Efficient Ethernet by calling
* phy_init_eee() and perform appropriate MAC configuration for EEE.
* Interface type selection must be done in mac_config().
*/
void mac_link_up(struct net_device *ndev, unsigned int mode,
phy_interface_t interface,
struct phy_device *phy);
#endif
struct phylink *phylink_create(struct net_device *, struct fwnode_handle *,
phy_interface_t iface, const struct phylink_mac_ops *ops);
void phylink_destroy(struct phylink *);
int phylink_connect_phy(struct phylink *, struct phy_device *);
int phylink_of_phy_connect(struct phylink *, struct device_node *, u32 flags);
void phylink_disconnect_phy(struct phylink *);
int phylink_fixed_state_cb(struct phylink *,
void (*cb)(struct net_device *dev,
struct phylink_link_state *));
void phylink_mac_change(struct phylink *, bool up);
void phylink_start(struct phylink *);
void phylink_stop(struct phylink *);
void phylink_ethtool_get_wol(struct phylink *, struct ethtool_wolinfo *);
int phylink_ethtool_set_wol(struct phylink *, struct ethtool_wolinfo *);
int phylink_ethtool_ksettings_get(struct phylink *,
struct ethtool_link_ksettings *);
int phylink_ethtool_ksettings_set(struct phylink *,
const struct ethtool_link_ksettings *);
int phylink_ethtool_nway_reset(struct phylink *);
void phylink_ethtool_get_pauseparam(struct phylink *,
struct ethtool_pauseparam *);
int phylink_ethtool_set_pauseparam(struct phylink *,
struct ethtool_pauseparam *);
int phylink_get_eee_err(struct phylink *);
int phylink_init_eee(struct phylink *, bool);
int phylink_ethtool_get_eee(struct phylink *, struct ethtool_eee *);
int phylink_ethtool_set_eee(struct phylink *, struct ethtool_eee *);
int phylink_mii_ioctl(struct phylink *, struct ifreq *, int);
#define phylink_zero(bm) \
bitmap_zero(bm, __ETHTOOL_LINK_MODE_MASK_NBITS)
#define __phylink_do_bit(op, bm, mode) \
op(ETHTOOL_LINK_MODE_ ## mode ## _BIT, bm)
#define phylink_set(bm, mode) __phylink_do_bit(__set_bit, bm, mode)
#define phylink_clear(bm, mode) __phylink_do_bit(__clear_bit, bm, mode)
#define phylink_test(bm, mode) __phylink_do_bit(test_bit, bm, mode)
void phylink_set_port_modes(unsigned long *bits);
void phylink_helper_basex_speed(struct phylink_link_state *state);
#endif