blob: 2dcb6d12d137153664bc4aa7b04983a409658a59 [file] [log] [blame]
* Solomon SSD1307 Framebuffer Driver
Required properties:
- compatible: Should be "solomon,<chip>fb-<bus>". The only supported bus for
now is i2c, and the supported chips are ssd1305, ssd1306, ssd1307 and
ssd1309.
- reg: Should contain address of the controller on the I2C bus. Most likely
0x3c or 0x3d
- pwm: Should contain the pwm to use according to the OF device tree PWM
specification [0]. Only required for the ssd1307.
- solomon,height: Height in pixel of the screen driven by the controller
- solomon,width: Width in pixel of the screen driven by the controller
- solomon,page-offset: Offset of pages (band of 8 pixels) that the screen is
mapped to.
Optional properties:
- reset-gpios: The GPIO used to reset the OLED display, if available. See
Documentation/devicetree/bindings/gpio/gpio.txt for details.
- vbat-supply: The supply for VBAT
- solomon,segment-no-remap: Display needs normal (non-inverted) data column
to segment mapping
- solomon,col-offset: Offset of columns (COL/SEG) that the screen is mapped to.
- solomon,com-seq: Display uses sequential COM pin configuration
- solomon,com-lrremap: Display uses left-right COM pin remap
- solomon,com-invdir: Display uses inverted COM pin scan direction
- solomon,com-offset: Number of the COM pin wired to the first display line
- solomon,prechargep1: Length of deselect period (phase 1) in clock cycles.
- solomon,prechargep2: Length of precharge period (phase 2) in clock cycles.
This needs to be the higher, the higher the capacitance
of the OLED's pixels is
- solomon,dclk-div: Clock divisor 1 to 16
- solomon,dclk-frq: Clock frequency 0 to 15, higher value means higher
frequency
- solomon,lookup-table: 8 bit value array of current drive pulse widths for
BANK0, and colors A, B, and C. Each value in range
of 31 to 63 for pulse widths of 32 to 64. Color D
is always width 64.
- solomon,area-color-enable: Display uses color mode
- solomon,low-power. Display runs in low power mode
[0]: Documentation/devicetree/bindings/pwm/pwm.txt
Examples:
ssd1307: oled@3c {
compatible = "solomon,ssd1307fb-i2c";
reg = <0x3c>;
pwms = <&pwm 4 3000>;
reset-gpios = <&gpio2 7>;
};
ssd1306: oled@3c {
compatible = "solomon,ssd1306fb-i2c";
reg = <0x3c>;
pwms = <&pwm 4 3000>;
reset-gpios = <&gpio2 7>;
solomon,com-lrremap;
solomon,com-invdir;
solomon,com-offset = <32>;
solomon,lookup-table = /bits/ 8 <0x3f 0x3f 0x3f 0x3f>;
};