| // SPDX-License-Identifier: (GPL-2.0-only OR BSD-3-Clause) |
| /* |
| * Copyright (C) STMicroelectronics 2025 - All Rights Reserved |
| * Author: Alexandre Torgue <alexandre.torgue@foss.st.com> for STMicroelectronics. |
| */ |
| #include <dt-bindings/interrupt-controller/arm-gic.h> |
| |
| / { |
| #address-cells = <2>; |
| #size-cells = <2>; |
| |
| cpus { |
| #address-cells = <1>; |
| #size-cells = <0>; |
| |
| cpu0: cpu@0 { |
| compatible = "arm,cortex-a35"; |
| reg = <0>; |
| device_type = "cpu"; |
| enable-method = "psci"; |
| }; |
| }; |
| |
| arm-pmu { |
| compatible = "arm,cortex-a35-pmu"; |
| interrupts = <GIC_SPI 368 IRQ_TYPE_LEVEL_HIGH>; |
| interrupt-affinity = <&cpu0>; |
| interrupt-parent = <&intc>; |
| }; |
| |
| arm_wdt: watchdog { |
| compatible = "arm,smc-wdt"; |
| arm,smc-id = <0xbc000000>; |
| status = "disabled"; |
| }; |
| |
| ck_flexgen_08: clock-64000000 { |
| compatible = "fixed-clock"; |
| #clock-cells = <0>; |
| clock-frequency = <64000000>; |
| }; |
| |
| ck_flexgen_51: clock-200000000 { |
| compatible = "fixed-clock"; |
| #clock-cells = <0>; |
| clock-frequency = <200000000>; |
| }; |
| |
| firmware { |
| optee { |
| compatible = "linaro,optee-tz"; |
| method = "smc"; |
| }; |
| |
| scmi: scmi { |
| compatible = "linaro,scmi-optee"; |
| #address-cells = <1>; |
| #size-cells = <0>; |
| linaro,optee-channel-id = <0>; |
| |
| scmi_clk: protocol@14 { |
| reg = <0x14>; |
| #clock-cells = <1>; |
| }; |
| |
| scmi_reset: protocol@16 { |
| reg = <0x16>; |
| #reset-cells = <1>; |
| }; |
| }; |
| }; |
| |
| psci { |
| compatible = "arm,psci-1.0"; |
| method = "smc"; |
| }; |
| |
| timer { |
| compatible = "arm,armv8-timer"; |
| interrupt-parent = <&intc>; |
| interrupts = <GIC_PPI 13 (GIC_CPU_MASK_SIMPLE(1) | IRQ_TYPE_LEVEL_LOW)>, |
| <GIC_PPI 14 (GIC_CPU_MASK_SIMPLE(1) | IRQ_TYPE_LEVEL_LOW)>, |
| <GIC_PPI 11 (GIC_CPU_MASK_SIMPLE(1) | IRQ_TYPE_LEVEL_LOW)>, |
| <GIC_PPI 10 (GIC_CPU_MASK_SIMPLE(1) | IRQ_TYPE_LEVEL_LOW)>; |
| arm,no-tick-in-suspend; |
| }; |
| |
| soc@0 { |
| compatible = "simple-bus"; |
| ranges = <0x0 0x0 0x0 0x0 0x80000000>; |
| dma-ranges = <0x0 0x0 0x80000000 0x1 0x0>; |
| interrupt-parent = <&intc>; |
| #address-cells = <1>; |
| #size-cells = <2>; |
| |
| rifsc: bus@42080000 { |
| compatible = "simple-bus"; |
| reg = <0x42080000 0x0 0x1000>; |
| ranges; |
| dma-ranges; |
| #address-cells = <1>; |
| #size-cells = <2>; |
| |
| usart2: serial@400e0000 { |
| compatible = "st,stm32h7-uart"; |
| reg = <0x400e0000 0x0 0x400>; |
| interrupts = <GIC_SPI 102 IRQ_TYPE_LEVEL_HIGH>; |
| clocks = <&ck_flexgen_08>; |
| status = "disabled"; |
| }; |
| }; |
| |
| syscfg: syscon@44230000 { |
| compatible = "st,stm32mp21-syscfg", "syscon"; |
| reg = <0x44230000 0x0 0x10000>; |
| }; |
| |
| intc: interrupt-controller@4ac10000 { |
| compatible = "arm,gic-400"; |
| reg = <0x4ac10000 0x0 0x1000>, |
| <0x4ac20000 0x0 0x20000>, |
| <0x4ac40000 0x0 0x20000>, |
| <0x4ac60000 0x0 0x20000>; |
| #interrupt-cells = <3>; |
| interrupt-controller; |
| }; |
| }; |
| }; |