blob: 47fc64922fe07b0dd4c6fba11fd55a22e721e0b3 [file] [log] [blame]
Netlogic XLP Family GPIO
This GPIO driver is used for following Netlogic XLP SoCs:
XLP832, XLP316, XLP208, XLP980, XLP532
This GPIO driver is also compatible with GPIO controller found on
Broadcom Vulcan ARM64.
Required properties:
- compatible: Should be one of the following:
- "netlogic,xlp832-gpio": For Netlogic XLP832
- "netlogic,xlp316-gpio": For Netlogic XLP316
- "netlogic,xlp208-gpio": For Netlogic XLP208
- "netlogic,xlp980-gpio": For Netlogic XLP980
- "netlogic,xlp532-gpio": For Netlogic XLP532
- "brcm,vulcan-gpio": For Broadcom Vulcan ARM64
- reg: Physical base address and length of the controller's registers.
- #gpio-cells: Should be two. The first cell is the pin number and the second
cell is used to specify optional parameters (currently unused).
- gpio-controller: Marks the device node as a GPIO controller.
- nr-gpios: Number of GPIO pins supported by the controller.
- interrupt-cells: Should be two. The first cell is the GPIO Number. The
second cell is used to specify flags. The following subset of flags is
- trigger type:
1 = low to high edge triggered.
2 = high to low edge triggered.
4 = active high level-sensitive.
8 = active low level-sensitive.
- interrupts: Interrupt number for this device.
- interrupt-controller: Identifies the node as an interrupt controller.
gpio: xlp_gpio@34000 {
compatible = "netlogic,xlp316-gpio";
reg = <0 0x34100 0x1000
0 0x35100 0x1000>;
#gpio-cells = <2>;
nr-gpios = <57>;
#interrupt-cells = <2>;
interrupt-parent = <&pic>;
interrupts = <39>;